Lab Hunter Paper Brightness Meter Colorimeter Color Tester
- yante
- china
- 7
- 50
Electronic Tearing Tester is an intelligent testing instrument used to measure the tearing performance of sheets such as paper and cardboard.
Brightness and Color Tester is a detection instrument for measuring the color, chromatic aberration and whiteness of objects based on the principle of light reflection.
Product Function
Product Features
Advanced circuit design effectively guarantees the accuracy and stability of the measurement data
Can store 10 reference samples and have power-off protection, calibration data will not be lost after power-off
Standard RS232 interface, with computer software for communication (Purchased separately)
Application Range
Paper, cardboard, pulp, ceramics; Cement, starch, calcium carbonate, talc and other powders.
Standards
GB/T 7973,GB/T 7974,GB/T 7975,GB/T 8940.2,GB/T 1840,GB/T 13025,GB/T5950
GB/T 9338,GB/T 4739,GB/T 1543,GB/T 10339,GB/T 12911,ISO 2470,ISO 2471
Supporting Accessories And Consumable
Technical Parameters
maintenance
1、When the instrument is not in use, cover it for protection and keep it clean.
2、After use, turn off the instrument power switch and cut off the power supply.
3、After testing the powder sample, clean the test hole and sample holder with clean gauze to avoid contamination of subsequent samples with powder.
4、Do not touch the working surface of the standard with your hands. If necessary, a cotton ball dipped in anhydrous ethanol can be used to wipe the working standard board to remove dirt. After using the black tube, it should be placed with the opening facing downwards to prevent dust from falling. Store the standard device in the accessory box and keep it clean.
5、Do not touch the light source bulb and optical components with your hands. When cleaning is needed, use tweezers to clip Cotton wool and dip it in absolute ethanol to scrub.
6、Frequently used instruments should be replaced with new light bulbs every year. Open the rear cover plate, loosen the two screws located in the upper part of the four screws on the side of the lamp holder, wear clean gloves, pull out the old bulb upwards, and replace it with a new one. Pay attention to the height of the filament being flush with the center of the condenser, and tighten the screws.